How to configure a static IP address on CentOS 7

Last updated on November 7, 2020 by Dan Nanni

Question: On CentOS 7, I want to switch from DHCP to static IP address configuration with one of my network interfaces. What is a proper way to assign a static IP address to a network interface permanently on CentOS or RHEL 7?

If you want to set up a static IP address on a network interface in CentOS 7, there are several different ways to do it, varying depending on whether or not you want to use Network Manager for that.

Network Manager is a dynamic network control and configuration system that attempts to keep network devices and connections up and active when they are available). CentOS/RHEL 7 comes with Network Manager service installed and enabled by default.

To verify the status of Network Manager service:

$ systemctl status NetworkManager.service

To check which network interface is managed by Network Manager, run:

$ nmcli dev status

If the output of nmcli shows connected for a particular interface (e.g., enp0s3 in this example), it means that the interface is managed by Network Manager. You can easily disable Network Manager for a particular interface, so that you can configure it on your own for a static IP address.

Here are two different ways to assign a static IP address to a network interface on CentOS 7. We will be configuring a network interface named enp0s3.

Configure a Static IP Address without Network Manager

Go to the /etc/sysconfig/network-scripts directory, and locate the configuration file of the interface (ifcfg-enp0s3). Create it if not found.

Open the configuration file and edit the following variables:

In the above, NM_CONTROLLED=no indicates that this interface will be set up using this configuration file, instead of being managed by Network Manager service. ONBOOT=yes tells the system to bring up the interface during boot.

Save changes and restart the network service using the following command:

# systemctl restart network.service

Now verify that the interface has been properly configured:

# ip add

Configure a Static IP Address with Network Manager

If you want to use Network Manager to manage the interface, you can use nmtui (Network Manager Text User Interface) which provides a way to configure Network Manager in a terminal environment.

Before using nmtui, first set NM_CONTROLLED=yes in /etc/sysconfig/network-scripts/ifcfg-enp0s3.

Now let's install nmtui as follows.

# yum install NetworkManager-tui

Then go ahead and edit the Network Manager configuration of enp0s3 interface:

# nmtui edit enp0s3

The following screen will allow us to manually enter the same information that is contained in /etc/sysconfig/network-scripts/ifcfg-enp0s3.

Use the arrow keys to navigate this screen, press Enter to select from a list of values (or fill in the desired values), and finally click OK at the bottom right:

Finally, restart the network service.

# systemctl restart network.service

and you're ready to go.

Support Xmodulo

This website is made possible by minimal ads and your gracious donation via PayPal or credit card

Please note that this article is published by Xmodulo.com under a Creative Commons Attribution-ShareAlike 3.0 Unported License. If you would like to use the whole or any part of this article, you need to cite this web page at Xmodulo.com as the original source.

Xmodulo © 2021 ‒ AboutWrite for UsFeed ‒ Powered by DigitalOcean